Ulin big base min-max.

The river should be on the left. The main base is placed at the bottom of any side. After installing each of the drawing parts, select all the buildings and press tabb (to turn off the power) the entire base should turn on simultaneously when all the parts are installed, the seeds are loaded, the water is supplied, and all the pipelines are connected. Part 1 - EFO016i1a30Oo3728O83e The first part is placed in the upper left corner. Part 2 - EFO01Eu24e51AeoiE3uIa It is placed in the upper left corner of the drawing, adjacent to the first drawing. Part 3 - EFO01o0834uUE4628IieO It is placed in the middle left part, under the first drawing, and close to the edge Part 4 - EFO0158OEA297AuiaeIoe It is placed next to part 3 on the left and part 2 on the top. Part 5 - EFO016i1a30Oo3744O83e Close to the left edge and close to part 2 from above. MUST! restore the warehouse unloading node and install Cuprious Ore there In the lower left part of the drawing. Part 6 - EFO011ea0u9E8uU1E34O7 The last part is easy to install, and the reference point is the link section of the warehouse, right next to part 5 on the left and part 4 on the top. We load the seeds based on the drawings, and we restore the pipe that goes from the leftmost and lowest purification module. We connect both modules using a connector and lead the pipe to the nearest reactor. We supply water to all the remaining pipes on the left using two pumps in each pipe. We build two pumps, connect them to a single pipe, and supply them to the pipeline module, which should be placed next to the pumps. Now we connect this module to the pipeline supply module in drawing 4. We take drawing 3 and connect the leftmost pipeline outlet module to the pipeline supply module in drawing 4, in the rightmost part of the base. Next, we take and connect the second pipeline outlet module from drawing 3, which is located on the right, to the pipeline supply module from drawing 6, which is not far away.A minimum of 750 ferium bottles in WH.